We made some temporary changes around our stove. I didn’t want to spend big money redoing the backsplash tile since we plan to renovate the kitchen in a year or two. This was the perfect solution. Looks nice and easy to clean.

Great value for the buck. Used it to put it in the side of the stove and works like a charm. Very pleased with the product. One of the sides came bent but with a little heat it went straight again. Best bang for your buck if you’re looking for an easy fix like me!

We bought a new range/stove and oven in stainless to replace our old white one. It had a different profile on the wall than the old one and the wall looked shabby. I considered just painting but then I found this simple sheet of stainless. It was more expensive than paint but way, way simpler and it looks GREAT! It ties the stainless microwave above to the stove below and looks almost like a single unit. WAY WAY easier to clean.

Item has rust on edges and back of panel. Contacted seller and sent pictures. Was told they would ship replacement directly. Been 3 weeks and still nothing.

Poorly packed. Only one of the four black corner shipping protectors remained in place. Two were broken and the other had fallen off. As a result one corner was bent and there was some local damage along one edge. The finish was brighter than expected although it was brushed. Brighter than the brushed stainless range hood over the top. Also the four corner fasteners were very small and will probably need replacing with time.

While the description of the product indicates this is stainless, it lacks magnetic properties. If you were planning on using magnetic accessories, like me, then look elsewhere. Install was simple enough, although the pre-drilled holes were a bit small for my liking. I used #6 screws to anchor and had to ream out the holes a bit to get the screws to feed smoothly. Once installed, the backsplash looks good. Although it maybe prone to smudging. I'm going to oil it and hope that reduces the visible fingerprinting and marking. It works well enough, but I wish it were magnetic.

Came very well packaged with the corners reinforced with plastic guards. Didn't have the 4 screws, but I have a lifetime of "some assembly required" so I found some screws in my toolbox. Had to drill a couple more holes, and this stainless is very hard. TIP: If you install it without pulling the stove out as I did, put a couple of pieces of duct tape on it so you won't drop it behind the stove. You can tape it to the hood while you install the screws.

looks great behind my stove